Abdulsalam M. Alhawsawi

This study investigated the effects of reinforcing pure copper with hybrid B4C and Si3N4 nanoparticles on the mechanical and physical properties of the nanocomposite matrix. The composite matrix was prepared using the powder metallurgy (PM) method, allowing uniform nanoparticle dispersion within the copper matrix. The PM method was a practical approach for achieving a homogeneous and good dispersion of the reinforcing particles in the matrix while controlling the porosity and improving the microstructure of the fabricated composite matrix. The addition of B4C and Si3N4 are both very hard and dense materials. When added to a material, they can fill voids and reduce porosity. This can lead to significant improvements in the material’s mechanical properties. The study found that adding hybrid B4C and Si3N4 nanoparticles enhanced the microhardness and mechanical properties of the nanocomposites. The improvements in the mechanical and physical properties of such composites containing 5% B4C were 21.6% and 18.4% higher than the copper base alloy. The findings suggest that including ceramic particles is a viable strategy for enhancing the mechanical characteristics of copper in its pure form. For example, adding 5% B4C particles to copper resulted in a 23% increase in Young’s modulus of the material while reducing electrical conductivity by 4.6%. On the other hand, the hybrid composite Cu/5%B4C + 2.5%Si3N4 showed a 32% improvement in Young’s modulus and 71% in the microhardness value compared to the base metal. This makes it a promising option for various engineering applications, such as high-performance electrical contacts and bearings.

Breast cancer remains one of the major causes of mortality among female cancer patients. This fact caused a spark in the medical field, which in turn helped to improve the diagnostic and treatment of breast cancer patients over the years making this field always active with new ideas and innovative methods. In our study, a new method was explored using an energy-resolving detection system made from a NaI (Tl) scintillation detector to detect the gamma photons from an Am-241 radiation source to try and construct an image by scanning the American College of Radiology (ACR) mammography phantom. In addition to the experimental work, a Geant4 Application for Tomographic Emission (GATE) toolkit was used to investigate more complex options to improve the image quality of mammographic systems, which is limited by the experimental setup. From the experimental setup, the researchers were able to construct an image using the 26.3 keV and the 59.5 keV energy photons, to show the largest size tumour (12 mm) in the ACR phantom. With an improved setup in the simulation environment, the majority of the ACR phantom tumours was visible using both energy windows from the 26.3 keV and the 59.5 keV, where the 26.3 keV yielded better quality images showing four tumours compared to three when using 59.5 keV. The simulation results were promising; however, several improvements need to be incorporated into the experimental work so that the system can generate high-resolution mammographic images similar to the ones obtained by the GATE simulation setup.

Radioisotope applications in industrial process inspection and evaluation using gamma-ray emitters provide otherwise unavailable information. Offering alternative gamma-ray sources can support the technology by complementing sources’ availability and radiation safety. This work proposes to replace gamma-ray from radioisotopes with prompt gamma-ray from the interaction of neutrons with stable isotopes injected into the industrial process or with the structural material of the industrial process equipment. Monte Carlo N-Particle Transport Code (MCNP5) was used to simulate the irradiation of two-phase flow pipes by 252 Cf neutron source. Two simulations were run for each pipe, with and without mixing the liquid phase with the stable isotope 157 Gd. The detected gamma-ray spectra were analysed, and images of the two phases inside the pipes were produced. The images were compared to images obtained from simulations of gamma transmission measurement using 60 Co. Furthermore, results for prompt gamma computed tomography (CT) were presented and discussed. The studies’ outcomes indicate the potential of prompt gamma-ray to carry out the sealed sources applications of gamma transmission measurements and imaging.