Anthony Leslie
Academic, Senior Lecturer, Senior Lecturer
Research Interests
Make your next move.
Prepare your application
Review drafts before you send them.
Explore related searches
About
Anthony Leslie is a Senior Lecturer at the University of the West Of Scotland, located in the United Kingdom. His research areas focus on aviation technology, including hydrogen-powered aircraft systems, aerodynamic characteristics of flexible wing designs, and computational fluid dynamics related to petroleum vapour dispersion. Recent publications reflect a commitment to advancing knowledge in these domains through both experimental and numerical methodologies.
Articles (5)
To meet the aviation emissions reduction targets, the performance characteristics in terms of power output, fuel consumption and propulsive efficiencies of hydrogen-powered aircraft have been reviewed and assessed. The design performance of an aircraft model (regional turboprop ATR 72-600) retrofitted with hydrogen-based propulsive systems was investigated, and comparisons are made against the conventional jet-fuelled propulsion. The hydrogen retrofit constituted two configurations; a fuel cell (FC) powered and direct combustion design. The power characteristics of the three propulsive configurations along with the fuel consumption and efficiencies have been numerically modelled and evaluated. The hydrogen retrofits in both architectures (FC and direct combustion) have been found to perform in line with required operational parameters. They have also demonstrated high level of efficiency in terms of reduced fuel consumption up to 50% for the FC retrofit and 80% for direct combustion design. The weight factor, however, poses a significant challenge to the feasibility of the hydrogen technology.
Year:
2025
The flexing/morphing concept is a means of improving wings’ aerodynamic performance. Morphing technology such as the fishbone active camber (FishBAC) design has demonstrated drag reduction of over 30% at moderate angles of attack (AoAs) and 40% at higher AoAs and tail deflections compared to plain flap systems. In the current study, a morphing FishBAC wing model was designed and built for experimental measurements. The rear 25% of the wing portion was made of a flexing element with a maximum deflection of 32°. The measurements were conducted in a subsonic wind tunnel instrumented with a two‐component force–balance system. The FishBAC model was shown to be effective in all tested configurations. It tended to be more aerodynamically effective and efficient at higher AoA and lower flex deflections. An increase in the lift coefficient of up to 25% and drag reduction of up to 37% were observed. The overall aerodynamic efficiency at higher AoAs in terms of glide ratio was up by 50% compared to a plain flap. The experimental measurements and data were complimented by computational fluid dynamic (CFD) simulations, where the aerodynamic characteristics were compared and validated. Overall, the experimental and CFD data compared well in the given range of AoAs and flex angles. However, the CFD data tends to overestimate the lift and drag coefficients at the high end of the AoA range.
Year:
2025
Year:
2024
Year:
2022
Year:
2021
Collaborators (1)
Andy Durrant
Academic, Senior Lecturer, Senior Lecturer
University of the West of Scotland OLD
Make your next move.
Prepare your application
Review drafts before you send them.