Damiano Monticelli

Hyaluronic acid is one of the most important ingredients in dermal fillers, where it is often cross-linked to gain more favorable rheological properties and to improve the implant duration. Poly(ethylene glycol) diglycidyl ether (PEGDE) has been recently introduced as a crosslinker because of its very similar chemical reactivity with the most-used crosslinker BDDE, while giving special rheological properties. Monitoring the amount of the crosslinker residues in the final device is always necessary, but in the case of PEGDE, no methods are available in literature. Here, we present an HPLC-QTOF method, validated according to the guidelines of the International Council on Harmonization, which enables the efficient routine examination of the PEGDE content in HA hydrogels.

The goal of accurately quantifying trace elements in ultrapure silicon carbide (SiC) with a purity target of 5N (99.999% purity) was addressed. The unsuitability of microwave-assisted acid digestion followed by Inductively Coupled Plasma Mass Spectrometry (ICP-MS) analysis was proved to depend mainly on the contamination induced by memory effects of PTFE microwave vessels and by the purity levels of acids, even if highly pure ones were used in a clean environment. A new analytical protocol for the direct analysis of the solid material by laser ablation coupled with ICP-MS (LA-ICP-MS) was then exploited. Different samples were studied; the best results were obtained by embedding SiC (powders or grains) in epoxy resin. This technique has the great advantage of avoiding any source of external contamination, as grinding, pressing and sintering pretreatments are totally unnecessary. Two different laser wavelengths (266 and 193 nm) were tested, and best results were obtained with the 266 nm laser. The optimized protocol allows the determination of elements down to the sub-mg/kg level with a good accuracy level.