Dmytro Ivanchenko

national technical university of ukraine “igor sikorsky kyiv polytechnic institute”
Country flagUkraine

Research Interests

ApplyKite TwinLearns as you apply

Make your next move.

Prepare your application

Review drafts before you send them.

Explore related searches

Articles (6)

Year:

2026

Year:

2026

Year:

2026

Year:

2025

Year:

2025

Peculiarities of phase and structural transformations during the carbon-thermal recovery of high-speed steel slag with the production of an alloying additive were investigated. This is necessary to determine the technological indicators that allow reducing the loss of high-value elements during the production and use of the alloying additive. A gradual change in the degree of scale reduction from 32 % to 69 % and 77 % led to an increase in the appearance of the solid solution of alloying elements and carbon in the α-Fe lattice with respect to FeWO4 and Fe3O4. Along with this, Fe3C, FeW3C, WC, VC, V2C, and Cr3C2 were manifested. At the same time, the formation of polyhedral and rounded particles of different chemical composition and the formation of a spongy microstructure was observed. It was determined that the most acceptable degree of recovery is 77 %. At the same time, the degree of reduction of 69 % is also sufficient since due to the residual carbon in the form of carbides, an increased reduction capacity is ensured with additional reduction of the oxide component in the liquid metal during alloying. The spongy microstructure provides relatively fast dissolution compared to standard ferroalloys, which causes a reduction in the total melting time while reducing the resources spent. No phases and compounds characterized by an increased tendency to sublimation were detected in the obtained alloying additive. That is, there is no need to provide additional conditions that prevent the loss of high-value elements during evaporation with the gas phase, which causes an increase in the degree of extraction of alloying elements. The indicators of the obtained alloying additive make it possible to melt alloyed steel in an electric arc furnace with respect to brands whose composition does not have strict restrictions on carbon, while replacing a part of standard ferroalloys.

Year:

2023

Collaborators (8)

Igor Vladymyrskyi

Professor

national technical university of ukraine “igor sikorsky kyiv polytechnic institute”

UKRAINE
View details

Minitsky Anatoly

professor

national technical university of ukraine “igor sikorsky kyiv polytechnic institute”

UKRAINE
View details

Ivan Lukianenko

Associate Professor

national technical university of ukraine “igor sikorsky kyiv polytechnic institute”

UKRAINE
View details

Iryna Kovalenko

Docent

national technical university of ukraine “igor sikorsky kyiv polytechnic institute”

UKRAINE
View details

Andrii Burmak

Associate Professor

national technical university of ukraine “igor sikorsky kyiv polytechnic institute”

UKRAINE
View details

Andrii Velychkovych

Ph.D., Associate Professor

-

UKRAINE
View details

Mykhail Yamshinskij

Head of the department

national technical university of ukraine “igor sikorsky kyiv polytechnic institute”

UKRAINE
View details

Maksym Barabash

Professor

national technical university of ukraine “igor sikorsky kyiv polytechnic institute”

UKRAINE
View details