Franciszek Hasiuk

Deep saline aquifers have been used for waste-fluid disposal for decades and are the proposed targets for large-scale CO2 storage to mitigate CO2 concentration in the atmosphere. Due to relatively limited experience with CO2 injection in deep saline formations and given that the injection targets for CO2 sometimes are the same as waste-fluid disposal formations, it could be beneficial to model and compare both practices and learn from the waste-fluid disposal industry. In this paper, we model CO2 injection in the Patterson Field, which has been proposed as a site for storage of 50 Mt of industrial CO2 over 25 years. We propose general models that quickly screen the reservoir properties and calculate pressure changes near and far from the injection wellbore, accounting for variable reservoir properties. The reservoir properties we investigated were rock compressibility, injection rate, vertical-to-horizontal permeability ratio, average reservoir permeability and porosity, reservoir temperature and pressure, and the injectant total dissolved solids (TDS) in cases of waste-fluid injection. We used experimental design to select and perform simulation runs, performed a sensitivity analysis to identify the important variables on pressure build-up, and then fit a regression model to the simulation runs to obtain simple proxy models for changes in average reservoir pressure and bottomhole pressure. The CO2 injection created more pressure compared to saline waste-fluids, when similar mass was injected. However, we found a more significant pressure buildup at the caprock-reservoir interface and lower pressure buildup at the bottom of the reservoir when injecting CO2 compared with waste-fluid injection.