Hyunsuk Choi

Introduction: Although various surgical techniques have been utilized in the reconstruction of severely resorbed alveolar bone, its regeneration is still regarded as a major challenge. Most of the surgical techniques used in advanced ridge augmentation have the disadvantages of prolonging the patient’s edentulous healing and increasing the need for surgical revisits because simultaneous implant placement is not allowed. This report presents a new and simplified method for advanced ridge augmentation, which utilizes a vertical tenting device. Case Presentation: The first case presented the reconstruction of the mandibular posterior region with severely resorbed alveolar bone due to peri-implantitis using tenting pole abutment for ridge augmentation. The second and third cases presented three-dimensional ridge augmentations in severely resorbed ridges due to periodontitis. The last case presented horizontal ridge augmentation using a vertical tenting device. All cases were performed under local anesthesia. Implants were simultaneously placed in the bone defect area. A vertical tensioning device was then connected to the implant platform to minimize the collapse of the bone graft during the bone regeneration period due to the contraction of the soft tissue matrix. A sticky bone graft was transplanted onto the exposed surface of the implant and on top of the vertical tensioning device. After covering with an absorbable barrier membrane, the soft tissues were sutured without tension. Conclusions: In all cases, prosthetic restorations were provided to patients after a bone grafting period of 5–6 months, leading to a rapid restoration of masticatory function. Results tracked for up to 6 years revealed observed stable reconstruction of the alveolar bone. The use of a vertical tenting device can prevent the collapse of biomaterials in the augmented ridge during the healing period, leading to predictable outcomes when achieving three-dimensional ridge augmentation.

Titanium (Ti) and Ti-based alloys are commonly used in dental implants, and surface modifications of dental implants are important for achieving osseointegration (i.e., direct connection between the implant surface and bone). This study investigated the effect of an eco-friendly etching solution—a hydrogen peroxide–sodium bicarbonate mixture—on the surface properties and contact angles of osteoblast adhesion and proliferation on Ti surfaces. Disk-shaped Ti specimens were prepared using different surface treatments (machining, sandblasting, and sandblasting/acid-etching), and they were immersed in the etching solution and ultrasonically cleaned. Surface characterization was performed using scanning electron microscopy, digital microscopy, contact angle analysis, and X-ray photoelectron spectroscopy. MG-63 osteoblasts were cultured on the specimens, and their adhesion to the specimen surface and proliferation were examined using staining and the MTT assay, respectively. Additional etching with the etching solution caused the formation of nano/micro hierarchical structures, increased surface roughness, and enhanced hydrophilicity. Osteoblast adhesion and proliferation were found to improve on the modified surfaces. The eco-friendly etching method has the potential to enhance the biological properties of Ti implant surfaces and thereby improve dental implant performance.