Ivan H. Beloev

A promising method of energy storage is the combination of hydrogen and compressed-air energy storage (CAES) systems. CAES systems are divided into diabatic, adiabatic, and isothermal cycles. In the diabatic cycle, thermal energy after air compression is discharged into the environment, and the scheme implies the use of organic fuel. Taking into account the prospects of the decarbonization of the energy industry, it is advisable to replace natural gas in the diabatic CAES scheme with hydrogen obtained by electrolysis using power-to-gas technology. In this article, the SENECA-1A project is considered as a high-power hybrid unit, using hydrogen instead of natural gas. The results show that while keeping the 214 MW turbines powered, the transition to hydrogen reduces carbon dioxide emissions from 8.8 to 0.0 kg/s, while the formation of water vapor will increase from 17.6 to 27.4 kg/s. It is shown that the adiabatic CAES SENECA-1A mode, compared to the diabatic, has 0.0 carbon dioxide and water vapor emission with relatively higher efficiency (71.5 vs. 62.1%). At the same time, the main advantage of the diabatic CAES is the possibility to produce more power in the turbine block (214 vs. 131.6 MW), having fewer capital costs. Thus, choosing the technology is a subject of complex technical, economic, and ecological study.

Monitoring the accuracy of meters by qualified workers and managers is a preventive measure of every organization. The paper focuses on monitoring the accuracy of measuring devices and proposes preventive and corrective actions. The discussed measurement device was tested for accuracy using accuracy indexes C g and C gk. The identified deviations in measurements showed that the meter was not fully efficient. Consequently, actions were taken to ensuring that the measurement device is accurate.