Ivica Papa
Associate professor
Research Interests
Make your next move.
Prepare your application
Review drafts before you send them.
Explore related searches
Articles (8)
Year:
2026
Year:
2025
Year:
2025
Year:
2025
Year:
2025
Year:
2024
This study compared oak butt-log volume estimations gained through terrestrial measurements in the forest stand with a remote approach using an unmanned aerial system (UAS) and photogrammetric post-processing. Terrestrial measurements were conducted in the lowland part of Croatia after a completed motor–manual final felling of a 140-year-old even-aged oak stand. Butt-logs’ volumes were estimated with four methods: the sectioning method and Huber’s, Smailan’s and Riecke–Newton’s methods. Measuring diameters and lengths and estimating volumes remotely were based on orthophotos using four different software: ArcGIS, QGIS, AutoCAD and Pix4D. Riecke–Newton’s method for volume estimation had the smallest relative bias of +1.74%, while for Huber’s method it was −8.07% and with Smailan’s method it was +21.23%. Log volume estimations gained remotely via ArcGIS and QGIS were, in the case of Huber’s method, at +3.63% relative bias, and in the case of Riecke–Newton’s method at +1.39% relative bias. Volume estimation using the sectioning method resulted in a total of 51.334 m3 for the whole sample, while the sectioning method performed with the help of AutoCAD resulted in 55.151 m3, i.e., +7.43% relative bias. Volume estimation of thirty oak butt-logs given by Pix4D software (version 4.8.4) resulted in +9.34% relative bias (56.134 m3). Comparing terrestrial measurements and the volume estimations based on them to those gained remotely showed a very high correlation in all cases. This study showed that using a UAS for log volume estimation surveys has the potential for broader use, especially after final felling in even-aged forests where the remaining trees in the stand would not block photogrammetric analysis.
Year:
2023
Forest roads, as a prerequisite for high-quality forest management, should be optimally distributed in order to avoid negative environmental impacts and to best fulfill their task. In the design phase of forest roads, it is necessary to know which factors influence most the volume of earthworks to enable the designer to best adapt to the terrain requirements. In this paper the impact of an average cross terrain slope and carriageway value of a forest road on cut and fill volume is analyzed. The research was carried out in the area of the management unit Trovrh–Kik, characterized by irregular terrain with slopes ranging between 27 and 58%, and on some micro locations even up to 84%. On eight forest roads, based on standard cross-section profiles, the influence of the average cross terrain slope and carriageway value (difference between ground level and grade level) of the forest road on the cut and fill volume per 1 m of the forest road route was analyzed. The obtained coefficients of determination indicate a strong correlation between the cut volume and carriageway value (R2 = 0.6841), and a moderate correlation between the fill volume and carriageway value (R2 = 0.5619). Unlike the influence of carriageway value on the cut and fill volume, the correlation between the cross terrain slope and fill volume is weak (R2 = 0.2076) or moderate in the case of the cut volume (R2 = 0.3167). On the basis of the analyzed standard cross-section profiles, it was determined that the carriageway value was 0.051 m, where the difference between the cut and fill volume was minimum and the average actual carriageway value was determined to be −0.09 m. It can be concluded that, on terrains with large and varying slopes, there is no unique model or terrain factor that could describe the earthworks required in the construction of a forest road. However, it is beyond doubt that the increase in the carriageway value and cross terrain slope caused the increase in the aforementioned volumes.
Year:
2023
Collaborators (5)
Andrea R. Proto
Professor (Associate) of Wood Technology and Forest Operations
Mediterranean University of Reggio Calabria
Andreja Đuka
-
Tomislav Poršinsky
Head of Department
university of zagreb
Kristijan Tomljanović
-
Piotr S. Mederski
Professor
University of Warmia and Mazury in Olsztyn
Make your next move.
Prepare your application
Review drafts before you send them.