Jakub Ochmann

The intensive development of renewable energy sources and the decreasing efficiency of conventional energy sources are reducing the flexibility of the electric power system. It becomes necessary to develop energy storage systems that allow reducing the differences between generation and energy demand. This article presents a multivariant analysis of an adiabatic compressed air energy storage system. The system uses a post-mining shaft as a reservoir of compressed air and also as a location for the development of a heat storage tank. Consideration was given to the length of the discharge stage, which directly affects the capital expenditure and operating schedule of the system. The basis for the analyses was the in-house numerical model, which takes into account the variability of air parameters during system operation. The numerical model also includes calculations of Thermal Energy Storage’s transient performance. The energy efficiency of the system operating on a daily cycle varies from 67.9% to 70.3%. Various mechanisms for economic support of energy storage systems were analyzed. The levelized cost of storage varies, depending on the variant, from 75.86 EUR/MWh for the most favorable case to 223.24 EUR/MWh for the least favorable case.

This article presents the results of an analysis of heat enhancement intensification using twisted tapes in linear absorbers for low-concentration parabolic trough collectors, a technology frequently considered as a supplementary energy source for industrial heat production. This contribution proposes a segmented application of different twisted tapes to intensify heat absorption. A 33.7 mm tubular absorber placed in the collector focal point with an aperture of 1.8 m was selected. The temperature range of the heat transfer fluid was chosen at 60–250 °C. The impact of inserts with twisted ratios of 1, 2 and 4 on system operation was analysed using the Ansys Fluent and mathematical model. The models used were validated based on experimental results from a parabolic trough collector with solar simulator test bench. The results indicated that for the range of mass flow between 0.15–0.3 kg/s, the most optimal is applying twisted ratio 1, except for the highest-temperature section. In this section, it is more optimal to use an insert with a twisted ratio 2, due to the lower need for pumping and the higher efficiency increment. The long-term analysis for the case study plant indicated that the proposed approach increased power gain by 0.27%.