Johan Arnqvist

Associate professor

Uppsala University
Country flagSweden

Research Interests

ApplyKite TwinLearns as you apply

Make your next move.

Prepare your application

Review drafts before you send them.

Explore related searches

Articles (4)

Year:

2026

An LES based model for the simulation of wind flows over realistic forests and topography is presented. Terrain elevation as well as forest density maps from airborne laser scans are employed to investigate the importance of specific model choices related to capturing upstream terrain effects on the wind resource. The study is divided in three parts. Firstly, an extended verification process over idealized conditions is carried out. Secondly, a validation where the model is compared to field measurements acquired in the south-east of Sweden and finally an assessment of the forest and terrain footprint based on variations of the surface representation. The results show an agreement of turbulence statistics compared to the literature when forest is explicitly modelled, following expected trends as a function of the tree density. When the forest is explicitly modelled the impact of the ground roughness becomes insignificant, even for an unrealistically sparse forest. The study also demonstrates that a model relying only on ground roughness yields notable differences in the turbulence characteristics. This is partly attributed to the inability of the model to reproduce sufficient drag for forest-equivalent values of roughness length z0 while maintaining the applicability of wall functions, which can impose strict limitations on the grid near ground. This is further complicated by the problem of converting realistic, heterogeneous forests fields to z0. Moreover, turbulence statistics in the roughness sublayer are affected by the lack of vertical permeability. The validation shows that the model is able to capture the flow characteristics imprinted by different surface features on the wind along three distinctive wind directions. Vertically separated spectral coherence from the LES is slightly below compared to the IEC standard, which can be attributed to the reference velocities used in the normalization of the frequency. The footprint study shows that the heterogeneity of a realistic forest produces higher drag in comparison with homogeneous conditions while also providing a better agreement with observations. An analysis based on correlations of upstream forest drag with target wind statistics shows that a point above the terrain is most significantly influenced by the footprint of a forest area located at about 10 times upstream of its height above ground. When correlations are applied to turbulence, this separation increases five-fold. These findings provide a valuable insight to determine the optimal domain size of a computational domain in forest simulations under neutral atmospheric stratification. Further comparisons of fully uniform vs. limited areas of realistic forest revealed that at heights above 100 m no clear differences in the wind flow are seen. Conversely, comparing flat terrain with the actual topography – with a realistic forest distribution on both cases – demonstrated a clear importance of capturing small scale terrain features.

Year:

2025

The late Permian to Triassic (~ 260-201 Ma) is one of the hottest periods in the last 500 Ma, witnessing dramatic changes in the environment on the Pangea supercontinent, extensive low mid latitude dusty desert formation and the development of a strong monsoonal regime (Ruffell & Hounslow 2006). However, one aspect of Permo-Triassic climate that is relatively unexplored is the extent to which orbital forcing drove terrestrial environmental change in the monsoon and desert areas. The terrestrial mudstone deposits of the Aylesbeare and Mercia Mudstone groups formed under a dusty desert environment crop out along the southwest coast of England (Hounslow and Gallois, 2023) and potentially provide a means to address this gap.Here we apply dual frequency magnetic susceptibility and analysis of its frequency dependence on mudstones of the Aylesbeare and Mercia Mudstone groups in order to constrain the environmental controls on these parameters and reconstruct Permo-Triassic environmental changes. We sample for these parameters at closely spaced regular intervals and use the new magnetostratigraphic timescale of Hounslow and Gallois (2023) to ascertain variations in these parameters with both age and depth. Both bulk magnetic susceptibility at low frequency (976 Hz) and frequency dependence show considerable variation, which correspond to stratigraphic alternations between green-grey silty mudstones and red mudstones, potentially reflecting wider scale changes in water table level and humidity. Evidence from temperature‐dependent magnetic susceptibility experiments suggested prevailing of magnetite in all types of sequences with hematite evidence in a red mudstone. We propose a model where changes in a dissolution of iron oxides due to climatically driven water table level changes explains these variations in the mudstones. Spectral and wavelet analysis reveals clear orbital periodicities in the proxy data, implying orbital control on water table in these desert environments, potentially via distal monsoon precipitation. Notably, there are substantial changes in the importance of key orbital parameters in the data through time, implying strong sensitivity of this hyper-arid climate to external boundary conditions. ReferencesRuffell, A. & Hounslow, M., 2006: In P. F. Rawson, & P. Brenchley (Eds.), The Geology of England & Wales. Geological Society of London; 295-325.Hounslow, M. & Gallois, R., 2023: Magnetostratigraphy of the Mercia Mudstone Group (Devon, UK): implications for regional relationships and chronostratigraphy in the Middle to Late Triassic of Western Europe. Journal of the Geological Society 180, jgs2022-173.

Year:

2025

As wind turbines have grown in size, it has become ever more costly to make the necessary tower-based wind observations needed both for the pre-operation (siting) phase and for wind turbine operations. In response to this challenge, the wind energy scientific community has - over the last decades - focused on evaluating and improving ground-based remote-sensing technology. The development has often been done in close collaboration with the innovative companies dedicated to providing the new solutions for replacing the expensive meteorological towers to the market. The project EARS4WindEnergy, which started in March 2023, represents one such effort. The project is focused on a re-exploration of the sodar technology, which preceded the later focus on wind lidars. Here, we present a benchmarking of the AQ510 sodar equipped with new signal processing technology with tall-tower data focusing on the three “must-perform” criteria of accurate wind speed, accurate turbulence intensity and a reliable identification of erroneous data. The complementary aspects of data availability and robustness in relation to current wind lidars is also discussed. Most of the presented data are taken at the Østerild test site in Northern Denmark, where a 244m tall tower allows for accuracy quantification over most of the sodar’s measurement range.

Year:

2025

Collaborators (5)

Dominika Niezabitowska

Institute of Geophysics, Polish Academy of Sciences

POLAND
View details

Ebba Dellwik

Technical University of Denmark

DENMARK
View details

Mikael Sjöholm

Senior Scientist

Technical University of Denmark

DENMARK
View details

B. Almqvist

Uppsala University

SWEDEN
View details

Thomas Stevens

Associate Senior Lecturer

Uppsala University

SWEDEN
View details