Keun-Hyeok Yang

The effect of a recently developed socket-type shear connector (SSC) on the flexural behaviour of a composite basement wall (CBW) was examined in this work. To this end, 12 CBWs composed of cast-in-place (CIP) piles fabricated with H-shaped steel beams or reinforcing steel plates were prepared by varying the arrangement and amount of SSCs. Two-point loading was applied to simply supported CBW specimens. The CBW specimens with more SSCs had a higher effective stiffness in the elastic state and higher moment capacity in the ultimate state, irrespective of the cross-sectional details of the CIP piles. These trends were particularly prominent when a reinforcing steel plate was used in the SSCs. The post-peak behaviour of the CBW specimens subjected to a simulated load with a negative external moment tended to be more ductile. Consequently, a higher degree of composite action was fully exerted on the CBWs with greater numbers of SSCs. Using established equations for the sectional details of CBWs with SSCs, the nominal partially composite to full composite flexural capacity ratios of the CBW specimens subjected to simulated loads with positive and negative external moments were calculated to be, respectively, 0.83 and 0.91 for 0.5η sc and 0.79 and 0.90 for 0.75η sc , where η sc is the normalised shear connector capacity specified in ANSI/AISC 360-16.