Michał Sarul

Excessive orthodontic force can induce inflammatory tooth root resorption due to sustained high stresses within the periodontal ligament (PDL). This study aimed to analyze the PDL pressures during upper incisor retraction using the en masse method with TISAD. The finite element method (FEM) ensured consistent conditions across cases. The models included bone geometry, adjacent teeth, PDL, and orthodontic hardware, analyzed with LS-Dyna. The pressure ranged from 0.37 to 2.5 kPa across the dental arch, with the central incisors bearing 55% of the load. The pressure distribution remained consistent regardless of the force or hook height. The critical pressure (4.7 kPa) was exceeded at 600–650 g force, with notable pressure (3.88 kPa) on the palatal root wall of the right central incisor. Utilizing 0.017 × 0.025 SS archwires in MBT 0.018 brackets provided good torque control and reduced the root resorption risk when forces of 180–200 g per side were applied, maintaining light to moderate stress. Triple forces may initiate resorption, highlighting the importance of nonlinear finite element analysis (FEA) for accurate oral cavity simulations.

The swift integration of ‘Gummetal’ into the orthodontic armamentarium can be attributed to its distinct advantages as an entirely new Ti-Nb-based beta titanium alloy. Developed by Toyota Central R&D Labs and publicly revealed in April 2003, this innovative material is rapidly reshaping orthodontic practices. Its sui generis properties allow its use as a potential substitute for the Multi-Loop Edgewise Archwire (MEAW) method. Three-dimensional orthodontic movement using this new alloy could eliminate the disadvantages of the MEAW method, such as its technical complexity and patient discomfort. In our comprehensive review of the current literature, we examined relevant publications sourced from the PUBMED database and explored one seminal work on Gummetal from the journal literature. Characteristic properties of Gummetal, such as its exceptional flexibility, superelasticity, and malleability (approximately 10 times greater than conventional metals), enable seamless formation of bends without posing challenges, thereby allowing precise control over orthodontic force application. Also worthy of mention are Gummetal’s biocompatibility and non-toxic properties, along with its low coefficient of friction. The wire seems to be a relatively easy way to achieve good occlusion. Its usage does not require extensive experience in terms of manual skill, and it is not time consuming. Diligent usage of any prescribed plastics by the patient is crucial to prevent complications and ensure successful orthodontic outcomes.