Michael Storchak
Professor
Research Interests
Make your next move.
Prepare your application
Review drafts before you send them.
Explore related searches
Articles (14)
Year:
2026
Year:
2026
Year:
2025
Year:
2025
Reducing the deviation effect from the specified machining conditions on the quality of the process in real time is the desired result of the intelligent spindle control system. To implement such a control system, a dynamic interaction model of the technological machining system with the cutting process was developed. The transfer matrix method of a multibody system was used in the development of the dynamic model. The physical closure condition of the technological machining system for using the transient matrix method is implemented in the developed model by introducing into this model an additional elastic coupling of the contact between the tool and the machined workpiece. The model is presented as a dynamic model of the elastic system “spindle unit–workpiece/tool–cutting process–tool/workpiece”. To develop the dynamic model, the system decomposition was performed with an analytical description of the joint deformation conditions of the subsystems and the use of the transient matrix method to calculate the harmonic influence coefficients of these subsystems. The proposed approach is used to calculate the native vibration frequencies of the spindle with the workpiece fixed in the chuck and supported with the tool. The calculation results correspond to the experimental ones and quite accurately represent their trends for different contact interaction conditions.
Year:
2023
The contact interaction mechanics of deformation broaching in low-plasticity materials is studied. Particular attention is paid to the study of the stress–strain state parameters and the plasticity margin in the deformation zone during the machining of gray cast iron EN-GJL-200. The stress–strain state was analyzed using a finite-element model of the deforming broaching process for each area of the deformation zone. The model parameters of the machined material were determined experimentally by compressing specimens of gray cast iron EN-GJL-200. The changes in the parameters of accumulated strain, stress tensor components, stress triaxiality ratio, hydrostatic stress, and plasticity margin at different deformation zones along the machined specimen depth are analyzed. It is shown that there is a zone of local plastic deformation in conditions of critical contact stresses. This leads to the appearance of tensile stresses that reduce the plasticity margin in the surface layer. The impact of tool geometry on the stress–strain state of the surface layer is also discussed, and recommendations for the optimal working angle of the deforming element are provided based on plasticity margin minimization.
Year:
2023
Year:
2023
Year:
2022
Year:
2022
Year:
2022
Year:
2022
Year:
2022
Year:
2022
Year:
2021
Collaborators (2)
Yurii Danylchenko
Head of the Department of Machine Design
national technical university of ukraine “igor sikorsky kyiv polytechnic institute”
Andrii Petryshyn
-
Make your next move.
Prepare your application
Review drafts before you send them.