Michal Holubcik
Researcher
Research Interests
Make your next move.
Prepare your application
Review drafts before you send them.
Explore related searches
Articles (16)
Year:
2026
Year:
2026
Year:
2026
Year:
2025
Year:
2025
Complying with strict PM10 and PM2.5 limit values poses challenges in many European regions, influenced by diverse factors such as natural, regional, and local anthropogenic sources. Urban air pollution, exacerbated by road transport, local industry, and dust resuspension, contrasts with rural areas affected by solid fuel-based local heating and increasing wood burning. This study focuses on village of Sučany, located in Slovakia, analysing PM concentrations during non-heating and heating seasons. The method of analysis relies on the use of the MP101M air quality analyser that utilises beta radiation absorption method. One set of measurements was conducted at five distinct locations during the heating season (18/01/2019 to 28/02/2019) and non-heating season (14/08/2018 to 1/10/2018). Significant differences emerged during the non-heating season with corresponding PM10 averages of 23.0 µg/m3 and PM2.5 at 19.3 µg/m3. In contrast, the PM10 averaged 53.9 µg/m3 and 52.8 µg/m3 during the heating season. The heating season shows PM2.5 contributing up to 98% of total PM10. The distribution of PM10 and PM2.5 pollution and the location of the potential source obtained using polar plots differed during the heating and non-heating seasons. This research underscores the impact of local heating on air quality in a typical Slovak village. The key recommendation for targeted interventions is supporting up-to-date air quality data, education, and financial incentives for citizens in order to implement cleaner and modern heating solutions.
Year:
2024
The COVID-19 pandemic brought a period of high consumption of protective masks and an increase in their waste. Therefore, it was necessary to look at possibilities for their disposal. This article is focused on the disposal of FFP2 masks in the form of pellets blended with sawdust. Further, their ash melting behavior was observed. The method of ash preparation can impact the resulting values of melting temperatures. Therefore, this article investigates the resulting values of ash melting temperatures determined during different ash preparations, such as temperatures (550 °C and 815 °C) and ash size (non-sifted, smaller than 50 µm and 100 µm). All measured deformation temperatures were higher than 1100 °C and even higher than 1200 °C for some samples. Moreover, the presence of FFP2 masks in pellets only insignificantly affected the values of melting temperatures compared to pure wood pellets. The measured values also showed that increasing the temperature of ash preparation from 550 to 815 °C can increase the resulting values of melting temperature. The most significant proportion of the fraction size on the resulting melting temperatures was observed for beech with 5% and 10% of masks at an ash temperature of 550 °C and for spruce with 10% of masks at an ash temperature of 815 °C.
Year:
2023
Agricultural and other residues are promising renewable energy sources. However, they can cause problems in combustion processes. One of these problems is also low ash melting temperatures. Except, the ash melting behavior can be impacted by many factors, such as ash preparation or used atmosphere. This article deals with comparing different atmosphere conditions during measurements of ash melting temperatures of three agricultural pellets: alfalfa, straw, and hay. The first one was oxidizing with compressed air and nitrogen. The second atmosphere was reduced with the air purge, and the last was only reduced, consisting of 60% carbon monoxide and 40% carbon dioxide. Differences between individual atmospheres were none, up to 9.8%. The most significant differences have appeared between oxidizing and reducing atmospheres. In general, the oxidizing atmosphere presents a less expensive way. More attention should be paid to the use of oxidizing atmosphere for applications in heat sources mainly due to its similarity to the combustion process. However, it would be suitable to realize more comprehensive research regarding ash preparation in different ways and with using of different types of fuel.
Year:
2023
Year:
2023
Year:
2023
Year:
2023
Year:
2023
Year:
2022
Year:
2022
Year:
2022
Year:
2022
Collaborators (3)
Nikola Čajová Kantová
Researcher
university of žilina
Alexander Čaja
university of žilina
Pavol Belány
-
Make your next move.
Prepare your application
Review drafts before you send them.