Orfeo Sbaizero

Actin-binding filamin C (FLNC) is expressed in cardiomyocytes, where it localizes to Z-discs, sarcolemma, and intercalated discs. Although FLNC truncation variants (FLNCtv) are an established cause of arrhythmias and heart failure, changes in biomechanical properties of cardiomyocytes are mostly unknown. Thus, we investigated the mechanical properties of human-induced pluripotent stem cells-derived cardiomyocytes (hiPSC-CMs) carrying FLNCtv. CRISPR/Cas9 genome-edited homozygous FLNCKO−/− hiPSC-CMs and heterozygous knock-out FLNCKO+/− hiPSC-CMs were analyzed and compared to wild-type FLNC (FLNCWT) hiPSC-CMs. Atomic force microscopy (AFM) was used to perform micro-indentation to evaluate passive and dynamic mechanical properties. A qualitative analysis of the beating traces showed gene dosage-dependent-manner “irregular” peak profiles in FLNCKO+/− and FLNCKO−/− hiPSC-CMs. Two Young’s moduli were calculated: E1, reflecting the compression of the plasma membrane and actin cortex, and E2, including the whole cell with a cytoskeleton and nucleus. Both E1 and E2 showed decreased stiffness in mutant FLNCKO+/− and FLNCKO−/− iPSC-CMs compared to that in FLNCWT. The cell adhesion force and work of adhesion were assessed using the retraction curve of the SCFS. Mutant FLNC iPSC-CMs showed gene dosage-dependent decreases in the work of adhesion and adhesion forces from the heterozygous FLNCKO+/− to the FLNCKO−/− model compared to FLNCWT, suggesting damaged cytoskeleton and membrane structures. Finally, we investigated the effect of crenolanib on the mechanical properties of hiPSC-CMs. Crenolanib is an inhibitor of the Platelet-Derived Growth Factor Receptor α (PDGFRA) pathway which is upregulated in FLNCtv hiPSC-CMs. Crenolanib was able to partially rescue the stiffness of FLNCKO−/− hiPSC-CMs compared to control, supporting its potential therapeutic role.

The production of glass foams obtained by recycling post-consumer glass and textile industry processing waste is presented. The mechanical, thermal and acoustic properties were characterized as a function of process temperature and time. The results showed that it is possible to produce glass foams with thermal and acoustic insulation properties from a mixture consisting of 96.5% of glass waste, 1% of textile waste and 2.5% of manganese dioxide, processed at temperatures between 800 and 900 °C for a time between 30 and 90 min. The samples had density in the range of 200–300 kg m−3, porosity of 87–92%, thermal conductivity of 85–105 mW m−1 K−1, noise-reducing factors of 0.15–0.40 and compressive strength of 1.2–3.0 MPa. Although their insulation performance was not as outstanding as that of polymer foams, these materials can emerge as competitive candidates for applications requiring non-flammability and high-temperature load bearing capacity in combination with low weight, mechanical strength, and thermal and acoustic insulation properties. The use of secondary raw materials (which accounted for 97.5% by weight of the synthetic blend) limits the energy required compared to that needed for the extraction, transportation and processing of primary raw materials, making these foams attractive also in terms of environmental footprint.