Przemysław Sander

This article presents the results of an assessment of the combustion process of blends of n-hexane and canola oil. Tests were conducted for pure canola oil and its blends with n-hexane, with a max. n-hexane content of 20% by volume. The tests were carried out using the constant volume combustion chamber (CVCC) method as well as a diesel engine. For comparison purposes, the results for typical diesel fuel are also presented. Tests on the self-ignition properties of the n-hexane–canola oil blend, conducted in a CVCC according to the normative method for diesel fuel, showed little effect on the combustion process. However, previous tests conducted on a diesel engine of a passenger car showed a favorable effect of the n-hexane addition to canola oil on the combustion process in the engine, the performance and environmental parameters obtained. This shows that for some fuels, the evaluation of self-ignition and combustion properties in a constant volume combustion chamber, under conditions corresponding to diesel fuel tests, is not sufficient. The findings of this research may be beneficial in optimizing the diesel engine combustion systems fueled by renewable fuels. As the results of the tests have shown, the standardized method for determining the combustion process of the CVCC method does not always fully reflect the results obtained in engine tests. The results obtained by the CVCC method can be successfully used when comparing fuels, but when considering the selection of fuel for the engine, the results obtained in engine tests should be relied on first and foremost.