R. V Markul

This paper reports the analysis of prospects for the use of prefabricated metal corrugated structures in the body of the embankment of a railroad track in the form of a tunnel overpass in order to pass road vehicles and railroad rolling stock. A technique of inertial dynamic tests of the deformed state of a tunnel overpass from prefabricated metal corrugated structures during the passage of railroad rolling stock is given, by measuring accelerations at the top and on the sides of overpass structures. An algorithm is proposed for processing the acceleration signal for assessing the strained state of metal corrugated structures of a tunnel overpass under the action of dynamic load from railroad transport. Experimental dynamic measurements of accelerations arising at the top and on the sides of a tunnel overpass during the passage of passenger and freight railroad rolling stock were carried out. The maximum value of accelerations arising at the top of a tunnel overpass during the passage of a freight train was 7.99 m/s2, and when passing a passenger train – 6.21 m/s2; the maximum accelerations that occur on the sides were 2.63 m/s2 and 1.77 m/s2. It is established that the maximum deformations of metal corrugated structures of the top of a tunnel overpass, when passing freight and passenger trains are, respectively, 1.63 mm and 1.11 mm. The maximum strains of metal corrugated structures on the sides of an overpass are 1.07 mm and 0.48 mm. The value of relative deformations in the vertical and horizontal dimensions of the structures of a tunnel overpass under the action of dynamic loads from the railroad rolling stock has been found. The relative vertical strains of an overpass amounted to 0.020 %; horizontal – 0.012 %. The practical significance of this work is that with the help of the devised procedure for measuring accelerations, it is possible to assess the strained state of metal corrugated structures under the influence of dynamic loads from the railroad rolling stock

Purpose. Given the need to improve the performance of modern mainline rolling stock, the authors analyze the possibility of using deeper regulation of attenuation. Methodology. The analysis of the operation of the thyristor-pulse converter of ER200 electric train is performed. It is established that in the acceleration mode at the limit traction characteristic it is necessary to consider two zones: the zone of constant value of traction force and the zone of constant power. A method for determining the minimum value of the attenuation coefficient for different types of DC and PC traction motors was proposed. The methods of theoretical research and analytical calculation of electrical circuits, theoretical foundations of electric traction, mathematical modeling of electrical and energy processes were used for the analysis. Findings. The complex of theoretical research and calculations allows confirming the technical possibility of deep attenuation use to regulate the speed regulation and obtain additional across-the-line positions for the rolling stock with DC and PC traction motors. The minimum attenuation coefficient value for different types of traction motors was determined. Originality. The methodology for determining the minimum value of the attenuation coefficient for traction motors of main electric locomotives in terms of using deeper magnetic flux control, replacing the use of experimental research data with theoretical studies. The essence of the studies is to form the required type of the limit traction characteristics by reducing the minimum permissible value of the excitation coefficient, which will reduce the electricity consumption. The research on determination of quantitative indicators of electricity consumption for the analysis of energy saving reserves on the main transport was further developed. Practical value. The results of theoretical research can be the basis for the modernization of main electric locomotives of direct and pulsating current with the systems of deep attenuation regulation. The research conducted will make it possible to create recommendations on designing the systems of magnetic flux regulation for traction engines with the improved technical and economic characteristics which are capable to increase the transport process efficiency on the main transport.