S. Karthikeyan

Senior Lecturer

Country flagUnited Arab Emirates

Research Interests

ApplyKite TwinLearns as you apply

Make your next move.

Prepare your application

Review drafts before you send them.

Explore related searches

Articles (9)

This study investigated incorporating fish scale powder (FSP) as a bio‐filler into polylactic acid (PLA) raw material for polymeric 3D printing. The PLA/FSP filaments were evaluated for various properties (tensile strength, tensile modulus, elongation, diameter deviation, thermogravimetric analysis, surface roughness, and SEM analysis) at different compositions (PLA, PLA/FSP10, PLA/FSP20, and PLA/FSP30 wt%). The results revealed that PLA filaments reinforced with 20 wt% FSP achieved the highest tensile strength, and modulus is 44.49 MPa and 2.83 GPa. The filaments reinforced with neat PLA and PLA with 10 wt% fish scale powder exhibited minor diameter deviations of +0.002 and −0.002. The surface roughness of the neat PLA filament is notably higher, registering a value of 1.459 μm. This finding highlights the importance of considering surface characteristics in filament selection for 3D printing applications. The microscopic analysis confirmed a uniform distribution of FSP particles in the 20 wt% composition PLA/FSP filaments. These results suggest that PLA/FSP (20 wt%) is an optimal feedstock for 3D printing, especially in developing biomaterials like bio‐scaffolds.

Year:

2023

Year:

2022

Year:

2022

Year:

2022

Year:

2022

Year:

2022

Year:

2022

Year:

2021

Year:

2021