Sung-Woon Cho

To fabricate oxide thin-film transistors (TFTs) with high performance and excellent stability, preparing high-quality semiconductor films in the channel bulk region and minimizing the defect states in the gate dielectric/channel interfaces and back-channel regions is necessary. However, even if an oxide transistor is composed of the same semiconductor film, gate dielectric/channel interface, and back channel, its electrical performance and operational stability are significantly affected by the thickness of the oxide semiconductor. In this study, solution process-based nanometer-scale thickness engineering of InZnO semiconductors was easily performed via repeated solution coating and annealing. The thickness-controlled InZnO films were then applied as channel regions, which were fabricated with almost identical film quality, gate dielectric/channel interface, and back-channel conditions. However, excellent operational stability and electrical performance suitable for oxide TFT backplane was only achieved using an 8 nm thick InZnO film. In contrast, the ultrathin and thicker films exhibited electrical performances that were either very resistive (high positive VTh and low on-current) or excessively conductive (high negative VTh and high off-current). This investigation confirmed that the quality of semiconductor materials, solution process design, and structural parameters, including the dimensions of the channel layer, must be carefully designed to realize high-performance and high-stability oxide TFTs.