Takayuki Takei

Associate Professor

Kagoshima University
Country flagJapan

Research Interests

ApplyKite TwinLearns as you apply

Make your next move.

Prepare your application

Review drafts before you send them.

Explore related searches

Articles (11)

Year:

2026

Chitosan hydrogels are effective wound dressings that promote healing through the synergy of chitosan’s inherent biological properties and the moist environment they maintain. We previously developed hydrogel microparticles using a highly biocompatible chitosan derivative with superior therapeutic effects. This study aimed to enhance their clinical translation for Endoscopic Sinus Surgery (ESS) by optimizing preparation conditions to achieve an extrusion force of <20 N, facilitating ergonomic, single-handed administration by surgeons. While reducing the particle size alone was insufficient to lower the extrusion force significantly, the introduction of a mechanical “kneading” process to de-agglomerate microparticle aggregates resulted in a substantial reduction in the required force from 213 ± 80 N to approximately 47 N. By further optimizing the polymer concentration to 5.0% (w/v), we successfully reduced the maximum extrusion force to below 20 N (17 ± 1 N). These results demonstrate that the optimized injectable chitosan gel microparticles achieve the practical usability required for precise surgical maneuvers during ESS.

Year:

2026

After endoscopic sinus surgery (ESS), nasal packing is often used to stop bleeding and promote wound healing. Because maintaining a moist environment is important to enhance wound healing, hydrogel-based wound dressings are effective to promote wound healing. Chitosan is used in the medical field because of its high hemostatic and wound healing properties. We developed a pH-neutral and non-toxic chitosan hydrogel, which was difficult to achieve using conventional methods. In this study, we show in animal experiments that the chitosan hydrogel (hydrogel particles) had higher wound healing properties than a commercially available solid wound dressing (dry state) composed of the same polymer. Additionally, we applied the injectable chitosan hydrogel particles as nasal packing materials to patients with bilateral chronic sinusitis undergoing ESS in a pilot clinical study. Concerning symptom scores, though the results narrowly missed statistical differences (p < 0.05), the average scores of our chitosan hydrogel were superior to those of a commercially available wound dressing (especially p = 0.09 for nasal bleeding). These findings suggest that the injectable chitosan hydrogel could be a viable option as a packing material following ESS.

Year:

2025

Year:

2025

Conventionally, chitosan hydrogels are acidic and contain toxic chemicals because chitosan is soluble only in acidic solvents and requires toxic additives such as chemical crosslinkers and polymerization agents to fabricate chitosan hydrogels. These properties prevent chitosan hydrogels from being used for medical applications. In this study, chitosan hydrogels were prepared by a simple and versatile process using urea hydrolysis by autoclaving (steam sterilization, 121 °C, 20 min). When autoclaved, urea hydrolyzes in an acidic chitosan aqueous solution, and ammonia is produced, which increases the pH of the solution, and chitosan becomes insoluble, leading to the formation of a chitosan hydrogel. The pH and osmotic concentration of chitosan hydrogels could be adjusted to be suitable for physiological conditions (pH: 7.0–7.5, and osmotic concentration: 276–329 mOsm/L) by changing the amount of urea added to chitosan solutions (chitosan: 2.5% (w/v), urea: 0.75–1.0% (w/v), pH: 5.5). The hydrogels had extremely low cytotoxicity without the washing process. In addition, not only pure chitosan hydrogels, but also chitosan derivative hydrogels were prepared using this method. The autoclaving technique for preparing low-toxic and wash-free sterilized chitosan hydrogels in a single step is practical for medical applications.

Year:

2024

Calcium alginate hydrogel is one of the most widely used materials for drug-carrier beads used in drug-delivery systems. In this study, we developed a new method to improve the encapsulation efficiency of ingredients, such as medicines, in calcium alginate hydrogel beads. In the gold standard method, the hydrogel beads are prepared in the liquid phase. In contrast, in the new method, to enhance the encapsulation efficiency, the hydrogel beads are prepared in the gas phase using a water-repellent surface. In brief, a droplet of sodium alginate aqueous solution is rolled on a water-repellent surface with CaCl2 powder, a cross-linking agent. This process leads to the direct attachment of CaCl2 powder to the droplet, resulting in the formation of spherical hydrogel beads with high mechanical strength and higher encapsulation efficiency than beads prepared by previous methods. The hydrogel beads exhibit similar permeability for glucose, a model for low-molecular-weight medicines, to those prepared by previous methods. These results show that the new method is promising for the preparation of calcium alginate hydrogel beads for drug-delivery systems.

Year:

2024

Year:

2023

Year:

2022

Year:

2022

Year:

2020

Year:

2020

Collaborators (4)

Yusuke Yamashita

Assistant professor

University of Miyazaki

JAPAN
View details

Yoichi Saito

Kumamoto University

JAPAN
View details

Kimihiro Okubo

Chairman, Professor

Nippon Medical School

JAPAN
View details

Yukio Fujiwara

Kumamoto University

JAPAN
View details