Wei Li
Research Interests
Make your next move.
Prepare your application
Review drafts before you send them.
Explore related searches
Articles (14)
In laser welding and additive manufacturing communities, the balling (humping) defect is primarily attributed to the Plateau–Rayleigh fluid instability (PRI) with a few authors suggesting fluid jetting and volume conservation as alternative mechanisms. As analytical descriptions of these mechanisms are unavailable, combining them into a single formalism is unfeasible. We present a new model of PRI with higher accuracy, accounting for competition with solidification, to compare the expected behavior with known experimental trends when fluid jetting is neglected. We adapt a rivulet instability model from fluid physics to account for the stabilizing effects of the substrate, which the traditional cylindrical-jet geometry does not account for and estimate the instability growth rate. Our model yields a continuous transition from non-balling to balling hitherto lacking in current literature and predicts instability growth at higher wavelengths with strong sensitivity to the solidification front curvature. While the fluid surface is most unstable for shallow melt pools, the absolute magnitude of balling relevant to printing defects scales with melt pool depth and has a maximum for a given melt pool geometry. Synchrotron-based x-ray radiography of thin samples indicates that PRI growth rates and solidification can be comparable in magnitude and thus compete, as we find in this work. We predict that deviations between model predictions and our experimental results demonstrate the importance of fluid flows and heat transport in the balling process. Our experiments further demonstrate at least one mechanism by which the melt pool length and the balling wavelength are not equivalent, as commonly claimed.
Year:
2026
Directed energy deposition (DED) additive manufacturing (AM) can fabricate, repair, and join near-net-shaped components for high-performance engineering applications, including biomedical, energy, and transport sectors. The broader adoption of DED remains constrained by the limited number of alloys available that can be reliably manufactured without imperfections, hence limiting mechanical properties. Here, we designed an Al–Ni–Ce–Mn–Fe AM alloy that can achieve an ultra-fine microstructure (<5 μm), uniform distribution of intermetallics, low residual stress (<32 MPa), and superior mechanical properties in as-built DED components. Compared to DED AlSi10Mg in the as-built state using the same conditions, the yield increased by 70%, and the ultimate tensile strength by 50%. DED-AM involves rapid cooling and complex thermal conditions, which largely influence the property of the final components. Post-characterization cannot capture the time resolved thermal behavior, hence offer limited mechanism-based guide for alloy design. In this study, we develop a novel multimodal characterization methodology for correlative in situ X-ray imaging, X-ray diffraction, and infrared imaging, enabling quantification of the in situ thermal-related behavior, including phase evolution, temperature distribution, and stress accumulation during DED. We elucidated key mechanisms driving the structure refinement and stress development in this alloy. The insights gained into the interplay between alloy composition, thermal-related behavior, and performance under specific AM conditions inform next-generation material design tailored for AM technologies.
Year:
2026
Year:
2026
Year:
2025
Year:
2024
Year:
2024
Year:
2022
Year:
2022
Year:
2022
Year:
2021
Year:
2021
Year:
2021
Year:
2021
Year:
2020
Collaborators (5)
Chu Lun Alex Leung
Associate Professor in Advanced Manufacturing
University College London
Dmitry G. Eskin
Professor
-
Leora Dresselhaus-Marais
Assistant Professor
Stanford University
Peter Lee
Professor
University College London
Kai Zhang
Lecturer
University College London
Make your next move.
Prepare your application
Review drafts before you send them.