Young Tae Cho

The sustained water repellency of interconnected micropatterned surfaces is explored over an extended duration, with a focus on their resilience during a 90‐day water‐immersion test. Initially, the microstructure surfaces exhibit high water repellency, a characteristic of the Cassie–Baxter state. However, subsequent detailed temporal analyses reveal varying responses depending on the structural topology. The interconnected micropatterned surfaces exhibit remarkable long‐term resistance to water; this is attributed to the formation of large and stable air pockets enabled by their unique microcavity structures. In comparison, hierarchical microcavity surfaces with micropillars exhibit a notable decrease in water repellency, as evidenced by reduced contact angles, suggesting a transition to a wetting state owing to the emergence of surface hydrophilicity during long‐term water exposure. This study demonstrates the importance of stable air‐pocket effects, particularly in applications where the long‐term stability of liquid repellency is critical, and suggests the role of interconnected structures in maintaining water repellency over time.

In underwater laser beam machining (ULBM), water provides a cooling effect by reducing the influence of the laser heat source, which makes ULBM more suitable for marking, cutting, and postprocessing than laser beam machining (LBM). Because the laser heat source not only affects the substrate temperature, but also heats the water, this study analyzes how the cooling effect occurs when water is heated. In this study, the heat-transformed zones in ULBM and heated underwater laser beam machining (HULBM) were improved by approximately 33% and 24%, respectively, compared to LBM at 400 W. In addition, the heat-affected zones in ULBM and HULBM improved by approximately 15% and 9%, respectively, compared to LBM. The hardness of ULBM and HULBM was higher than that of LBM. Based on these results, it was confirmed that water can reduce the effect of the laser heat source and improve the mechanical properties. Experiments will be conducted on the underwater laser beam machining of various substrates, such as Inconel718 and Ti-6Al-4V, in a future study. In addition, experiments will be conducted on the underwater laser beam machining of various substrates using a cooling system that can lower the temperature of water.