Zeinab El-Sayegh
Assistant Professor
Research Interests
Make your next move.
Prepare your application
Review drafts before you send them.
Explore related searches
About
Dr. Zeinab El-Sayegh is an Assistant Professor at Ontario Tech University in Canada. Her research focuses on tire-road interaction, tire modeling, and advanced simulation techniques. Recent publications include works on dynamic acceleration loading for racing tires, non-pneumatic tire designs, and the computational analysis of truck tire behavior. Dr. El-Sayegh's expertise contributes significantly to advancements in automotive and transportation engineering.
Articles (7)
Year:
2025
Vehicles often experience low tire pressures and high torques in off-road operations, making tire–rim slip likely. Tire–rim slip is undesirable relative rotation between the tire and rim, which, in this study, is measured by the relative tire–rim slip rate. There is little research on the effect of different terrains on tire–rim slip despite its significance for off-road driving; therefore, this topic was explored through Finite Element Analysis (FEA) simulations. An upland sandy loam soil was modelled and calibrated using Smoothed-Particle Hydrodynamics (SPH), and then a Regional Haul Drive (RHD) truck tire was simulated driving over this terrain, with a drawbar load added to increase drive torque. To examine their effects, five parameters were changed: tire–rim friction coefficient, longitudinal wheel speed, drawbar load, vertical load, and inflation pressure. The simulations showed that increasing the tire–rim friction coefficient and the inflation pressure decreased the tire–rim slip while increasing the vertical and drawbar loads increased the tire–rim slip. Varying the longitudinal wheel speed had no significant effect. Tire–rim slip was more likely to occur on the soil because it happened at lower drawbar loads on the soil than on the hard surface. These research results increased knowledge of tire–rim slip mechanics and provided a foundation for exploring tire–rim slip on other terrains, such as clays or sands.
Year:
2024
In this research, an 8 × 8 scaled electric combat vehicle (SECV) is built. The scaled vehicle is evaluated in both experimental and simulated methods to analyze its performance. The scaled vehicle is developed to apply the Ackermann condition by implementing the individual steering and individual wheel speed control system at low speed. Individual eight-wheel rotational velocity control and individual eight-wheel steering angle control in real time are developed and installed on the remotely controlled scaled vehicle to meet a perfect Ackermann condition. Three different steering scenarios are developed and applied: a traditional steering scenario (first and second axle steering), fixed third axle steering scenario (first, second, and fourth axle steering), and all-wheel steering scenario. Stationary evaluation, turn radius evaluation, and double lane change evaluation are conducted to verify the application of the Ackermann condition. The differences between the experimental results and the simulated data are within an acceptable range. An important demonstration of this research is the novel validation of physical and simulated data in the application of the Ackermann condition for eight-wheel steering and velocity control for the three steering scenarios.
Year:
2024
Year:
2024
Year:
2024
Year:
2024
Year:
2023
Collaborators (1)
Moustafa El-Gindy
Professor
Ontario Tech University
Make your next move.
Prepare your application
Review drafts before you send them.