Karsten Fleischer

Selective laser sintering (SLS) of copper components manufactured via powder metallurgy is widely studied due to minimal material wastage. However, copper has poor optical absorption when exposed to infrared (IR) lasers, such as in laser-based additive manufacturing or laser surface processing. To address this issue, an innovative approach to enhance the optical absorption of copper powders during infrared laser sintering is presented in this study. Carbon nanotubes (CNTs) have several unique properties, including their high surface area, plasmonic response, excellent conductivity, and optical absorption properties. CNTs were mixed with copper powders at different weight percentages using an acoustic method. The resulting Cu-CNT compositions were fabricated into pellets. The Box-Behnken Design of Experiments methodology was used to optimize the IR laser processing conditions for sintering. Spectroscopic analysis was conducted to evaluate the reflection and thermal absorption of the IR wavelengths by the Cu-CNT composites. Density and hardness measurements were taken for the laser-sintered Cu-CNT pellets. The coating of copper powders with CNTs demonstrated enhanced optical absorption and correspondingly reduced reflection. Due to the enhanced optical absorption, increased control and sensitivity of the laser sintering process was achieved, which enabled improvement in the mechanical properties of strength, hardness, and density, while also enabling control over the composite thermal expansion coefficient. A maximum average hardness of 66.5 HV was observed. Indentation test results of the samples revealed maximum tangential and radial stresses of 0.148 MPa and 0.058 Mpa, respectively.