Maria Chiara Bignozzi

Traditional Portland cement-based composites have a great environmental impact. Alkali-activated binders can offer an alternative, particularly if they can be obtained even partially from waste. Two residuals derived from the finishing steps of the traditional ceramic industry have been used as possible polymerizable sources mixed with metakaolin. Moreover, to contrast the low dimensional stability of alkali-activated materials and their mechanical brittleness, natural fibers derived from the Arundo donax plant have been added to the mortars. The use of renewable natural fibers instead of synthetic ones can contribute a further environmental advantage. The fresh (consistency) and cured (mechanical) properties of composite materials prepared with residuals and metakaolin were analyzed here. For comparison’s sake, a reference set of composite materials not loaded with fibers but with an identical binder/sand and liquid/binder ratio was cast. A room-temperature curing condition was selected that, although inadequate to promote the short-time reactivity of the wastes, has a minimal energy requirement and allows on-site applications. A small-scale decrease in the properties in the compression mode tests was observed in the waste-modified mortars, while the Arundo addition improved their flexural strength and dimensional stability.

Aluminum alloys are extensively used to manufacture mechanical components. However, when exposed to alkaline environments, like lubricants, refrigerants, or detergents, they can be corroded, reducing their durability. For this reason, the aim of this study is to investigate the influence of aggressive alkaline solutions (i.e., pH and presence of chlorides) on the corrosion resistance of three aluminum alloys (AA 5083-H111, AA 6082-T6, and AA 7075-T6) with and without anodizing treatments. Open circuit potential (EOCP) and anodic polarization measurements were carried out and typical corrosion parameters such as corrosion current density (icor) and corrosion rate (CR) were determined. Morphology of the corrosion attack and samples microstructure were investigated by scanning electron microscope. Results show that corrosion behavior of the three investigated alloys is influenced by (i) the aggressiveness of the testing environments; (ii) the thickness of the anodizing treatment; (iii) the alloy chemical composition; (iv) the distribution of intermetallic phases in the aluminum matrix. Moreover, three galvanic series have been built also testing other metallic alloys commonly used in mechanical applications, i.e., carbon steel (C40), stainless-steel (AISI 304), and Cu-based alloys (Cu-Ni alloy and CW 617 N, respectively). Results clearly indicate that galvanic series play a fundamental role when it is necessary to select an alloy for a specific environment, highlighting the thermodynamic conditions for corrosion occurrence. On the other hand, kinetic measurements and microstructural studies carried out on the three aluminum alloys stress the importance of the surface treatments and relevant thickness as well as the effect of metal exposure. Future work will involve the study of other surface treatments on aluminum alloys and the evaluation of their corrosion behavior in acidic environments.