Maria Pia Sammartino

Electrical conductivity is one of the main parameters for the characterization of water solutions and for the monitoring of water sources. In this paper, we describe a very inexpensive prototype for conductivity measurements based on Arduino UNO R3 coupled to an open-source circuit board with only passive components. We designed the printed circuit board (PCB) and the suitable handmade cell using stainless-steel electrodes and wrote the freeware management software; the assembly of the prototype, including a temperature probe, and results were relatively simple. In order to allow for replicates, the instrument design, schematics, and software are available with an open-source license. Thirty-one bottles of spring waters with conductivities of between 15.2 and 2000 µS cm−1 were tested using both this prototype and a commercial conductivity meter. Data correlation produced an equation that allowed us to obtain the conductivity value, starting with the value furnished by the Arduino apparatus in arbitrary units. The prototype is accurate enough (inaccuracy lower than 6% excluding very low conductivity values) and precise (RSD% of about 5%). Even if a lot of commercial instruments for conductivity are available, we propose a prototype built with the aim of lowering the cost of measurements, while ensuring that they remain useful for lab or in situ application, as well as for continuous water monitoring/management systems. A further aim was to propose the building of the instrument as a laboratory exercise; this can help students to better understand basic theoretical concepts regarding conductivity, electronic components, and the acquisition and treatment of analytical data.

In cultural heritage, unaesthetic stains on carbonate stones due to their close contacts with metals are of concern for the preservation of sculptures, monumental facades and archeological finds of various origin and antiquities. Rust stains made up of various oxidized iron compounds are the most frequent forms of alteration. The presence of ferric iron on rust-stained marble surfaces was confirmed in previous studies and oriented the choice of the best cleaning method (based on complexing agents specific for ferric ions). However, the composition of rust stains may vary along their extension. As the corrosion of the metallic iron proceeds, if the oxygen levels in the surroundings are low and there are no conditions to favor the oxidation, ferrous ions can also diffuse within the carbonate structure and form a variety of intermediate compounds. In this study, the iron stains on archeological marbles were compared with those artificially produced on Carrara marbles and Travertine samples. The use of integrated techniques (optical and scanning electron microscopy as well as Mössbauer and XPS spectroscopy) with complementary analytical depths, has provided the overall information. Rust formation and diffusion mechanisms in carbonates were revealed together with the evolution of iron speciation and identification of phases such as ferrihydrite, goethite, maghemite, nanomagnetite, and hematite.