Christopher Juhlin
Professor
Research Interests
Make your next move.
Prepare your application
Review drafts before you send them.
Explore related searches
Articles (28)
Surface fibre-optic distributed acoustic sensing (S-DAS) typically requires trenching to achieve adequate coupling, which can be challenging and costly in hardrock environments. As an alternative, untrenched S-DAS offers significant time and cost savings, though at the expense of data quality. In this study, we systematically evaluated the impact of untrenched deployment on DAS data quality through a multi-method comparison with conventional sensors, including three-component geophones and vertical-component accelerometers. All recorded data were converted to particle velocity to enable direct amplitude comparisons across arrays. Phase fidelity was assessed using the surface-wave method, cross-power spectral analysis, and ambient noise interferometry. Untrenched S-DAS recorded amplitude levels that differed from those of conventional sensors, particularly above 50 Hz. However, within the surface-wave band (up to 35 Hz), the data quality was sufficient to derive reliable shear-wave velocity profiles, especially when the data were resorted to common-receiver gathers. Sensitivity and coherence decreased significantly at higher frequencies and larger offsets, and a systematic time delay was observed for DAS in the surface-wave band. Ambient noise interferometry was ineffective for the untrenched DAS array, largely due to variable channel coupling and system-specific noise. This study provides a systematic field comparison of untrenched S-DAS and conventional sensors in hardrock settings, outlining both the limitations and the practical potential of this cost-effective deployment method.
Year:
2026
Year:
2025
This study revisits seismic reflection data from the Central Scandinavian Caledonides, initially acquired during campaigns in the late 1980s and early 1990s. Previous analyses faced challenges in merging and imaging due to varying trace spacing and data gaps, particularly in the western parts. To address these limitations, we spatially resampled the data to a consistent trace spacing, carefully merged segments, and migrated the entire merged section. This approach resulted in a revised seismic profile, with notable changes in the western section where the image reveals key differences compared to earlier interpretations. The updated profile indicates near-continuous reflections across merged segments, resolving issues of abrupt breaks present in some prior publications. Enhanced imaging in the western section unveils new structural details, including collapsed diffractions and shorter reflective segments, offset from one another. These reflecting segments in the Skardöra antiform are interpreted as representing dolerite sills that were once continuous over a larger area but have been offset by normal faulting. This reinterpretation suggests a significantly thinner upper allochthon in the west than in previous interpretations. These results emphasize the importance of careful data integration and migration for seismic interpretation, shedding new light on the structural complexity of the western Scandinavian Caledonides. The study contributes to refining geological models and advancing understanding of the region's tectonic history.
Year:
2025
Passive seismic data were acquired together with active seismic data along a 2.8 km long profile in the Sudret area of Gotland, Sweden, as part of a feasibility study for storage of CO2 below the Baltic Sea. Seismic interferometry using cross-correlation and cross-coherence was employed on the passive seismic data. Cross-correlation was used to retrieve virtual shot gathers containing mainly surface waves, while cross-coherence was used to retrieve mainly seismic reflections. Inversion for shear wave velocity and CDP processing of the passive data result in velocity profiles and images that correlate well with borehole data, synthetic seismograms and active seismic data acquired at the site. Interpretations of the passive surface wave and body wave results provide geological information which complement the active data results, the surface waves providing S-wave velocity information and the body waves providing an image that may have better signal quality at deeper levels. Results from the active seismic and passive seismic data correlate well and there is no indication of any large-scale faults in the area. Furthermore, analysis of the frequency and direction of the ambient noise using power spectral density and beam forming show that ocean waves and human activity around the island of Gotland make the Sudret area an ideal location for passive imaging through ambient noise interferometry. Our results illustrate that passive seismic imaging can be an important complement to active seismic data for structural studies of the subsurface with respect to CO2 storage and monitoring in the Gotland area, Sweden, and perhaps elsewhere.
Year:
2025
Reflection seismic data were acquired in the Sudret area of Gotland between 6 and 13 November 2023. Objectives of the survey were to obtain images of the subsurface down to the Precambrian basement in the vicinity of two cored boreholes that had been drilled earlier down to about 800 m. The seismic profiles were positioned to provide a better understanding of the sedimentary strata and local structure near the two boreholes. It was also hoped that they could be used to correlate the properties of the geological formations offshore for studying the potential of future geological storage of CO2 within Swedish waters. For these purposes a sparse 3D survey was acquired that covered a ca. 300 m by 700 m rectangular area with high fold, including the locations where the boreholes were drilled. A longer ca. 2.8 km 2D profile was also acquired adjacent to the 3D survey that ran roughly in a N–S direction. In addition, distributed acoustic sensing (DAS) measurements were performed in the two cored boreholes. We report here on some results from the 2D and 3D surveys and from the DAS measurements, incorporating information from the core and sonic logs. Numerous semi-continuous reflection horizons are observed in the ca. upper 500 ms after stacking. A particularly strong reflection at about 330 ms likely originates from the top of Ordovician limestones. Generation of synthetic seismograms based on the acquired sonic logs in the two boreholes confirms this interpretation. Cambrian sandstones are also reflective, as well as shallow sandstone layers in the upper 150 ms. Normal moveout (NMO) velocities are relatively constant at about 3500 m s−1. However, depth conversion using this velocity places the reflectivity deeper than is expected from the well data. In comparison, using the DAS data, the vertically propagating P-wave velocity can be measured at an average 3100 m s−1 from the surface to 580 m depth. Using this velocity for depth conversion provides more reasonable depths to the main horizons. Since the NMO velocities are largely controlled by the horizontal velocity of the rock the difference between these and the DAS velocity can be explained by the rocks in the area having significant anisotropy. Seismic modeling indicates that a horizontal velocity of about 3500 m s−1 is necessary to explain the difference between the NMO velocity and the vertical velocity. This corresponds to an anisotropy of about 13 %. This may be important to take into account when acquiring and processing future, or legacy, offshore seismic data for the purpose of mapping potential structures or formations for CO2 storage.
Year:
2025
Near-surface seismic reflection surveys can produce high-resolution geological structural images for engineering and hydrological investigations. To help delineate shallow subsurface complex geological structures in a karst area and to better understand limestone cave formation, a high-resolution 2D seismic reflection profile was acquired and processed in the urban area of Shenzhen, China. The stacked images detail subsurface structures down to depths of 80–90 m, including a concave shaped reflection that curves upwards, two thrusts and one normal fault, as well as a hard rock basement reflection at the southern end of the profile which could not be mapped by borehole investigations due to the limited drilling depth. Our interpretations correlate well with borehole data and were supported by synthetic seismic modelling. Limestone caves are mainly found along faults and near rivers in this area. The results provide new insight on the formation mechanism and distribution of the karst caves. Movement along faults and erosion generated fractures and fissures in the limestone that provide channels for rainwater and groundwater to circulate. These waters, rich in carbonic acid, dissolve minerals in the limestone, resulting in the formation of underground cavities.
Year:
2025
We present a structural and depositional interpretation in the southeasternmost Sorgenfrei–Tornquist Zone (STZ), one of the most prominent Late Cretaceous compressional inversion structures in Northern Europe. Detailed stratigraphic analysis of seismic facies and well data shows that the spatial and temporal variability of gravitational deposits, contourite drifts, and moats in the marginal troughs are related to the polyphase inversion tectonic history and the associated palaeoceanographic changes. The Hanö Bay and Bornholm Basin contain a sand‐rich mounded depositional feature proximal to the STZ. This unit is resolved with high vertical resolution in seismic data and represents a clear example of a siliciclastic‐carbonate mixed depositional system, where deposition was controlled by the interplay between inversion events and eustatic sea‐level changes. Following the progradational and aggradational deposition during an early inversion phase and tectonic quiescence, a notable back‐stepping pattern is observed in the upper Santonian–lower Campanian. The increased accommodation space outpaced sediment infill during eustatic sea‐level rise in the late Santonian. We interpret that the marginal trough subsided during multiple inversion pulses associated with elastic flexure in response to inversion tectonics. The comparison of sequence‐stratigraphic indicators and the global (eustatic) sea‐level curve allows for a refined reconstruction of the inversion history and points to a major uplift in the Santonian–Campanian. Further, we attribute a penecontemporaneous change in the depositional pattern, i.e., the erosional Campanian–Maastrichtian contourite moat system, to intensified bottom current activity related to significant global cooling, in conjunction with the palaeoceanographic modification induced by the inversion tectonics described in this study.
Year:
2025
Borehole seismic investigations play a major role for high‐resolution imaging of geological structures at depth. The resulting borehole seismic data enable a direct characterisation of the target units as well as their physical properties along the well and in its direct vicinity. Analysing seismic data acquired at different scales within the borehole provides additional notable insights and allows an improved geological and petrophysical interpretation. In our work, we processed zero offset vertical seismic profiling data and full waveform sonic log data as part of a multiscale borehole seismic imaging workflow to better characterise a mineral exploration target at Ludvika Mines (Blötberget mining area, Central Sweden). Data processing mainly comprised wavefield separation and corridor stacking, followed by migration of the full waveform sonic log data using a diffraction stack approach. Additional borehole data, that is, impedance logs and a lithological borehole profile, were used for the integrated interpretation to provide the basis for an assignment of the reflectors to a specific lithological unit. Besides the existing structural models derived from surface seismic investigations, the new images from borehole seismic data reveal the internal structure of the mineralisation at a significantly higher resolution, complement the geophysical characterisation and can be used for a subsequent reliable mineral resource estimate.
Year:
2025
Passive seismic data were acquired together with active seismic data along a 2.8 km long profile in the Sudret area of Gotland, Sweden, as part of a feasibility study for storage of CO2 below the Baltic Sea. Seismic interferometry using cross-correlation and cross-coherence was employed on the passive seismic data. Correlation was used to retrieve virtual shot gathers containing mainly surface waves, while cross-coherence was used to retrieve mainly seismic reflections. Inversion for shear wave velocity and CDP processing of the passive data result in velocity profiles and images that correlate well with borehole data, synthetic seismograms and the active seismic data. Both the passive surface wave and body wave results provide geological information which complement the active data, the surface waves providing S-wave velocity information and the body waves providing a lower frequency image. The passive data are consistent with the active data and there is no indication of any large-scale faults in the area. Furthermore, analysis of the frequency and direction of the ambient noise using power spectral density and beam forming shows that ocean waves and human activity around the island of Gotland makes the Sudret area an ideal location for passive imaging. Our results illustrate that passive seismic imaging can be an important complement to active seismic data for evaluating the subsurface with respect to CO2 storage and monitoring in the Gotland area, Sweden, and perhaps, elsewhere.
Year:
2025
This study revisits seismic reflection data from the central Scandinavian Caledonides, initially acquired during campaigns in the late 1980s and early 1990s. Previous analyses faced challenges in merging and imaging due to varying trace spacing and data gaps, particularly in the western parts. To address these limitations, we spatially resampled the data to a consistent trace spacing, carefully merged segments, and migrated the entire merged section. This approach resulted in a revised seismic profile, with notable changes in the western section where the image reveals key differences compared to earlier interpretations. The updated profile indicates near-continuous reflections across merged segments, resolving issues of abrupt breaks present in some prior publications. Enhanced imaging in the western section unveils new structural details, including collapsed diffractions and shorter reflective segments, offset from one another. These reflecting segments in the Skardöra antiform are interpreted as representing dolerite sills that were once continuous over a larger area, but have been offset by normal faulting. This reinterpretation suggests a significantly thinner Upper Allochthon in the west than in previous interpretations. These results emphasize the importance of careful data integration and migration for seismic interpretation, shedding new light on the structural complexity of the western Scandinavian Caledonides. The study contributes to refining geological models and advancing understanding of the region's tectonic history.
Year:
2025
Year:
2025
Year:
2025
Year:
2025
Year:
2025
Year:
2025
Year:
2025
Year:
2025
Year:
2023
Year:
2023
Year:
2022
Year:
2022
Year:
2022
Year:
2022
Year:
2022
Year:
2022
Year:
2022
Year:
2022
Year:
2022
Collaborators (11)
Alireza MALEHMIR
Professor in applied geophysics
Uppsala University
Ayse Kaslilar
Uppsala University
Gregor Giebel
Technical University of Denmark
Michael Kühn
Professor for Hydrogeology
Helmholtz Centre Potsdam – GFZ German Research Centre for Geosciences
Thomas Kalscheuer
Professor
Uppsala University
Junhyung Lee
-
Iwona Klonowska
Assistant Professor
AGH University of Science and Technology
Henning Lorenz
staff scientist (research infrastructure specialist)
Uppsala University
B. Almqvist
Uppsala University
Tae-Kyung Hong
Professor
Yonsei University
Magdalena Markovic
Assistant Professor
Uppsala University
Make your next move.
Prepare your application
Review drafts before you send them.